STUDI PERILAKU KOROSI TEMBAGA DENGAN VARIASI KONSENTRASI ASAM ASKORBAT (VITAMIN C) DALAM LINGKUNGAN AIR YANG MENGANDUNG KLORIDA DAN SULFAT

Authors

  • Soejono Tjitro Faculty of Industrial Tehnology, Petra Christian University
  • Juliana Anggono Faculty of Industrial Tehnology, Petra Christian University
  • Gatut Phengkusaksomo Alumnus, Faculty of Industrial Tehnology, Petra Christian University
  • Adriana Anteng Anggorowati Department of Chemical Engineering, Widya Mandala University

Keywords:

corrosion rate, inhibition efficiency, ascorbic acid

Abstract

Planned Interval Test method conducted in several intervals of times (0-5) days, (0-10) days, (0-15)) days, and (10-15) days shows the changes of environment condition and metal corrosion. The changes in the corrosiveness media and the corrosion resistant of the material. The acidity of the media gets lower from 7.6 to 7.1 in the interval of (0-5) days and the conductivity increase during the time interval. The change in acidity is caused by hydrolisis reaction and AA decomposition. During the time interval of (10-15) days a very high corrosion rate was observed due to low pH and high conductivity. The highest efficiency is found in the addition of 150 ppm AA in all different concentration of Cl - and SO4 2- in water. More or less AA concentration, AA has no function as inhibitor. The amount is not enough to form the protective film on the metal surface and some are used to form the chelate compounds with the metal ions. Abstract in Bahasa Indonesia : Pengujian dengan metode Planned-Interval Test dalam interval waktu (0-5) hari, (0-10) hari, (0-15) hari dan (10-15) hari menunjukkan perubahan kondisi lingkungan dan perilaku korosi tembaga. Perubahan kondisi lingkungan ini ditunjukkan oleh penurunan pH dan peningkatan nilai konduktivitas lingkungan. Penurunan pH dari 7,6 ke 7,1 pada interval waktu (0-5) hari karena reaksi hidrolisis dan dekomposisi asam askorbat (AA). Sedangkan nilai konduktivitas yang semakin tinggi disebabkan oleh semakin banyaknya ion-ion terlarut dalam lingkungan. Kedua perubahan ini menimbulkan peningkatan pada korosivitas lingkungan. Korosivitas tertinggi dijumpai pada interval waktu (10-15) hari , terbukti dengan laju korosi paling besar. Efisiensi AA tertinggi untuk semua variasi lingkungan NaCl dan CaSO4 terjadi pada 150 ppm. Kurang atau lebih dari 150 ppm , AA tidak akan berfungsi sebagai inhibitor karena selain jumlah AA yang tidak memadai untuk inhibisi juga dipakai bersama ion logam membentuk senyawa kelat yang meningkatkan laju korosi. Kata kunci: laju korosi, efisiensi inhibisi, asam askorbat

Downloads

Published

2004-06-29

Issue

Section

Articles