Pemesinan Laju Tinggi dan Pemesinan Kering Menggunakan Pahat Karbida pada Bahan Aluminium 6061

Authors

  • Bobby Umroh Universitas Tjut Nyak Dhien Medan, Jl. Gatot Subroto/Jl. Rasmi No 28, Medan 20123
  • Surya Murni Yunus Institut Teknologi Medan, Jl. Gedung Arca No 52, Medan 20217
  • Syamsul Basri Institut Teknologi Medan, Jl. Gedung Arca No 52, Medan 20217

Keywords:

High-speed machining, cutting force, surfaceroughness, surface defect.

Abstract

Research of high speed machining and dry machining use for the best cutting conditions on the roughness aluminum 6061 material surface using a carbide tool. Collection machining test data is performed 4 times trial with 3 main variable is the rate of cutting (V), Ingestion rate (f) and depth of cut (a) at three levels of scale. The best surface roughness conditions is determined by the rate of the cemetery, where the rate of feeding is recommended at f = 0.12 mm/rev or < 0:17 mm/rev. Effect of cutting force is inversely proportional to the value of rate of cuts. At the greater of the cutting force so the surface roughness also getting smaller. Depth of cut and rate cuts also affects on the surface roughness but not in any condition determined. At the lowest state with V = 1000 m/min f = 0:12 mm/rev and a = 1 mm, surface defects (surface defect). Possibly, this is caused by the vibration of the tool due to lack of dynamic balance in the cutting process.

References

Itoigawa, F. et al, Effects and Mechanisms in Minimal Quantity Lubrication Machining of an Aluminium Alloy, Journal of Materials Process¬ing Technology, 2006.

Kishway, H. et al, Effect of Coolant Strategy On Tool Performance, Chip Morphology and Surface Quality During High Speed Machining of A356 Aluminium Alloy, Journal of Materials Process¬ing Technology, 2005.

Jianwen, H.U. and Kevin Chou, Y., Characteri¬zations of Cutting Tool Flank Wear-land Con¬tact, Journal of Materials Processing Technology, 2007.

Kalpakjian, S., Manufacturing Process for Engi-neering and Technology, Third Edition, Addison Wesley Publishing Company,1995.

Rochim, T., Teori dan Teknologi Permesinan, HEDS. 1993.

Schultz, H. and Moriwaki, T., High speed Machining, Annals of the CIRPP, 1992.

Sreejith, P.S. and Ngoi, B.K.A., Dry Machining, Machining of the Future. J. Mater. Proc. Tech¬no¬logi, 2000.

Tugrul O¨ Zel and Karpat, Y., Predictive modeling of surface roughness and tool wear in hard turning using regression and neural networks, International Journal of Machine Tools & Manufacture, 45, pp. 467–479, 2005.

Downloads

Published

2013-10-01